|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
Hi,I just started monitoring this board...will be here a lot in the coming weeks...am building a home theater in the basement...framing will be done next week, then comes wiring...so:
1)What kind of wire should I use to run in the wall and across the ceiling to power my rear HT speakers? (It's about a twenty-five foot run.)2)Is there a good internet source for this wire? I frequent eBay...is there a good source there?
3) The whole home theater will be on its own breaker. Any advice on use of wire/outlets for that?
Thanks!
Dave
Follow Ups:
My HT room is on the first floor of the house. I ran PVC conduit from the wall behind the TV, underneath the floor, and coming out at each rear side wall where the rear surrounds go. This allows extreme flexibility for changing wires, etc. The ends of each duct are finished off with a solid faceplate with a hole drilled in the middle for the wire.Learn more about this technique on the PS Audio site under their Listening Room article.
This is such a great idea. I'm now thinking of changing the wire to my sorrounds since I've seen signs of corrosion in the wire. If I had done what you are suggesting this would be a piece of cake.
Helier
There is some useful reading material, (downloadable Adobe files), on www.crutchfield.com about HT wiring.Like you, I installed seperate 120AC breakers and feeds to the audio and video equipment. It is a good idea to run a minimum of three dedicated circuits. One for the video, (big screen, projector, etc), a second for the audio gear, (receiver, amp, etc), and third for the subwoofer. This way you will minimize any chance of ground loops between all the gear causing picture issue, or ground hum in a subwoofer.
Good luck.
Jim
Thanks. Jim. I will tell my electrician to make the three dedicated circuits. I visited Crutchfield, thanks for that tip, too.Dave
This post is made possible by the generous support of people like you and our sponsors: