Video Asylum

• Re: Use a receiver and 2 ch pre on same set of speakers?? - Estes 04:56:33 03/31/02 (3)
  In Reply to: Use a receiver and 2 ch pre on same set of speakers?? posted by vikvilkhu on March 31, 2002 at 01:51:13:

  If you get a receiver with preouts, run the front channels to your 2 channel pre and run the other speakers from the receiver. Will this change the sound. More than likely, but you may find that the difference is not that big on HT.
  
  

  ---

  • Re: Use a receiver and 2 ch pre on same set of speakers?? - vikvilkhu 07:36:08 03/31/02 (2)
    In Reply to: Re: Use a receiver and 2 ch pre on same set of speakers?? posted by Estes on March 31, 2002 at 04:56:33:

    I see what you're saying but that woudl require me to adjust the volume separately on two components and try to match levels by ear, right...a little annoying, which is why I wanted to simplify wth just a receiver.

    My new 2 channel preamp has no processor loop or such so my question was can I run a set of speaker wires from the receievr to all my speakers as well as run a set of speaker cables from my 2 channel amp to the front two speakers (which are still connected to the receiver)?
    
    

    ---

    • Re: Use a receiver and 2 ch pre on same set of speakers?? - skippy 10:31:05 04/24/02 (0)
      In Reply to: Re: Use a receiver and 2 ch pre on same set of speakers?? posted by img on April 24, 2002 at 10:30:40:

      as long as you dont't accidentally leave the power on the receiver and integrated simultaneously on
      
      

      ---
    • Use a speaker switch box - cfraser 09:33:27 03/31/02 (0)
      In Reply to: Re: Use a receiver and 2 ch pre on same set of speakers?? posted by vikvilkhu on March 31, 2002 at 07:36:08:

      They can be used to select between amps ("backwards") instead of between speakers i.e. two sources instead of two speakers. There are many brands of these, from cheap (like RS) to quite expensive. Something in the middle is the one from Bryston. You can also quite easily make a decent one with some good switches (like Shallco).

      Without a switch the operating amp will be feeding into the output of the non-operating amp, and the n-o amp will be loading the operating amp inappropriately: not good.
      
      

      ---

This post is made possible by the generous support of people like you and our sponsors:

Parts Connexion

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---