Video Asylum

• Re: Lexicon CP3 PLus - michael w 22:55:25 10/18/02 (0)
  In Reply to: Lexicon CP3 PLus posted by tazdevl on October 11, 2002 at 09:49:39:

  This processor is no longer supported by Lexicon.

  Follow the link below.

  
  cheerio
  

  • Future support for the CP3+

  
  

  ---
• Its use is limited - John C. - Aussie 23:16:49 10/13/02 (0)
  In Reply to: Lexicon CP3 PLus posted by tazdevl on October 11, 2002 at 09:49:39:

  First up forget about any further upgrade and I would not worry about lusting after an MC1. Dolby pro logic can be quite effective although I must admit PLII is a major improvement on what the CP3 has (and note the MC1 does not sport PLII).

  I had a CP3 for awhile and it was moderately effective at giving artificial ambience through rear speakers BUT do not expect too much from it.

  For starters I suggest you try using it as a processor on your front and rears. If you find it messes up the stereo sound (most likely) then use a feed out from your preamp to offer audio for the rears only. You can then turn it off when the rear signal irritates.

  For its time it was a most sophisticated unit but this area of electronics has progressed dramatically in the last few years. But as a freebie, what have you got to lose? Have fun experimenting.

  John
  
  Peace at AA
  
  

  ---

This post is made possible by the generous support of people like you and our sponsors:

Schiit Audio

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---