Video Asylum

• Re: Agree - Johnny Ca 09:21:23 07/12/06 (4)
  In Reply to: Agree posted by rico on July 12, 2006 at 09:13:50:

  I will tonight but the disc was X-men and it was pretty clear that a signal was being sent to the center channel (i.e., there was dialog) but no response.
  
  

  ---

  • setup - Joe Murphy Jr 21:00:01 07/12/06 (3)
    In Reply to: Re: Agree posted by Johnny Ca on July 12, 2006 at 09:21:23:

    Could your processor give you the option to independently configure DTS and Dolby processing? Perhaps the DTS setup needs to be "told" that you now have a Center channel?
    
    

    ---

    • Re: setup - Johnny Ca 07:43:30 07/13/06 (2)
      In Reply to: setup posted by Joe Murphy Jr on July 12, 2006 at 21:00:01:

      Good call - I thought of that too - there is a separate configuration menu for DTS and I double checked it but couldn't find anything that would cause the center channel to be MIA. I checked the manual but didn't find anything there either. However, the set-up is fairly complex and I was hoping someone who uses this processor and is more familiar than I with it would have some input.

      Thanks for the response thus far!
      
      

      ---

      • levels - Joe Murphy Jr 18:21:35 07/14/06 (1)
        In Reply to: Re: setup posted by Johnny Ca on July 13, 2006 at 07:43:30:

        From the Quick Setup guide on Theta's site, there is a Menu option to have the Center channel ON/OFF and also a Level setting for the Center channel. Dolby Digital and DTS can have independent settings. Could the DTS level setting be set to "0"?

        What DVD player are you using? I can't remember what happens to the digital output if a DVD player with a DTS decoder is set up for Center channel OFF. That's grabbing at straws, but what the hell.

        Hope you find the problem.
        
        

        ---

        • Problem solved! - Johnny Ca 09:41:43 07/15/06 (0)
          In Reply to: levels posted by Joe Murphy Jr on July 14, 2006 at 18:21:35:

          Good call on the DVD player - I thought about that last night, checked the setting and DTS was being output as "PCM" rather than bitstream. Changed the setting and everything works like a charm.

          Thanks for all the input!
          
          

          ---

This post is made possible by the generous support of people like you and our sponsors:

Kimber Kable

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---