In Reply to: How can I improve my cable signal posted by cashbin on March 7, 2002 at 18:01:13:
I'm assuming that when you only had one set hooked up the signal was
adequate.If, after the splitter was added, both lines were poor then it would probably be a signal strength problem.
If only one run is bad, it usually points to a poor connection somewhere on that run. I'd look for a poorly connected "F" connector there.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- The problem is on one line only? - Markw* 05:39:49 03/20/02 (0)