Video Asylum TVs, VCRs, DVD players, Home Theater systems and more.

---

[ Follow Ups ] Thread: [ Display  All  Email ] [ Video Asylum ]

---

[ Alert Moderator ] [ Edit ] [ Delete ]

---

Seperate amp for mains

12.37.14.229

Posted by Mick on January 5, 2001 at 05:31:19

In Reply to: Why not... posted by Michael on January 4, 2001 at 11:22:03:

Unfortunately my tube amp is a little to short on power. I'd say around 25W/ch. I use 6L6GC's in a push-pull configuration.

I've gotten a few suggestions similar to yours. The most common is to buy a A/V receiver for around $800 and take the difference and buy a power amp for the mains. Hook the power amp up to the receiver via the pre-outs.

Any problems with letting an amp sit idle? I assume not since they provide pre-outs. Also, if I use the receiver to drive my mains, do the receivers typically have a main in. See, my subs are matched to the mains using an active crossover. I would go pre-out -> active xover -> hi-pass to main-in -> low-pass to my subs power amp (Perreaux 2150b) -> stereo subs. Therefore, I would also not need the sub out of the receiver. Any problems with this?

Thanks for your advice!

Mick

This post is made possible by the generous support of people like you and our sponsors:

Parts Connexion

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---