In Reply to: Re: 2.1 Channel HT ? posted by DavidLD on January 22, 2006 at 08:59:38:
I do not recommend this suggestion as some AVRs put the A and B loads in series when both are selected and some introduce an impedance-adjusting resistor. You are better off running the sub from the dedicated sub output on the system (if you have such).If not and you must use speaker-level connections, connect all to the same sets of terminals or run the main L/R through the sub's network.
It would easier to give better advice if you posted the specific amp, speakers and sub you are using.
Kal
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Whoa. - Kal Rubinson 07:19:19 01/23/06 (6)
- Re: Whoa. - DavidLD 17:31:08 01/24/06 (0)
- Re: Whoa. - Pinkus 13:44:09 01/23/06 (4)
- And...................... - Kal Rubinson 15:00:53 01/23/06 (2)
- Re: And...................... - Pinkus 18:49:15 01/23/06 (1)
- Re: And...................... - Kal Rubinson 19:01:06 01/23/06 (0)
- And the amp is????????????? (NT) - Kal Rubinson 14:57:35 01/23/06 (0)