|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
67.168.135.161
'); } // End --> |
In Reply to: 2 Channel Setup for Home theater with Adcom GFP-750 posted by FICEJJ on October 05, 2004 at 13:46:41:
The Adcom has a home-theatre pass through,...essentially it allows an external processor to *see* and control the amp that the Adcom is connected too.L & R front channel rca's from HT Pre --> Adcom Pre ---> Amp that drives the front L&R. You could play the stereo/Adcom system with any source plugged into the Adcom. For home-theatre, select the pass-through on the Adcom and it disapears from the chain,...the Adcome *lets* the HT Pre control the amp, full run over volume control, balance etc.
Follow Ups:
Monk,
Thanks for the response. Could I then use the HT Pre with a seperate amp to power a center channel?
Yes, the HT pre's output for Center (and Surrounds) would go to the amps driving those speakers. The HT pre's outputs for front L and R go to the amps driving those speakers,...except routed through the Adcom (the HT by-pass switch on the Adcom, in an ideal world, means the Adcom disapears from the chain, the interconnect goes through the Adcom, but its not affected by it, its as if the HT was connected directly to the amp driving the fronts).The adcom could be used with a HT receiver too, if it has pre-outs as well as speaker level output. For stereo you'd have Source --> Adcom --> Stereo Amp ---> Front L and R, a normal stereo system. For home theater you'd have the receiver driving all the speakers except the Adcom would lend *its* amp to the receiver to drive the fronts.
I'm probably making it sound more complicated than it is,...basically you can just think of the pass-through switch allowing the HT rca output to get routed to the amp driving the Fronts,...through the Adcom without the Adcom having any effect on the signal (theoretically).
This post is made possible by the generous support of people like you and our sponsors: